Poweramp CM SERIES MECHANICAL Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Kladkostroj Poweramp CM SERIES MECHANICAL. Poweramp CM SERIES MECHANICAL User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 44
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
CM-Series
Dock Leveler
Owner’s/User’s Manual
Printed in U.S.A.
Copyright ©
2003
Manual No. 4111-0006
September 2010
PoweramP Division of Systems, Inc. • W194 N11481 McCormick Drive Germantown, WI 53022
800.643.5424 fax: 262.255.5917 www.docksystemsinc.com [email protected]
Zobrazit stránku 0
1 2 3 4 5 6 ... 43 44

Shrnutí obsahu

Strany 1 - CM-Series

CM-SeriesDock LevelerOwner’s/User’s ManualPrinted in U.S.A.Copyright © 2003Manual No. 4111-0006 September 2010PoweramP • Division of Systems,

Strany 2 - Table of Contents

84111-0006 — Sept 2010Sept 2012INTRODUCTIONComponent IdentificationA — LipB — Lip Maintenance PropC — PlatformD — Lip BangerE — Lip Assist SpringF —

Strany 3 - Safety-Alert Symbol

94111-0006 — Sept 2010Sept 2012INSTALLATIONPrepare Pit1. Before lowering the dock leveler into the pit, the following must be performed:2. Remove al

Strany 4 - Sept 2012

104111-0006 — Sept 2010Sept 2012INSTALLATIONPoweramp dock levelers are designed with installation in mind. Each unit is shipped with lifting brackets

Strany 5

114111-0006 — Sept 2010Sept 2012INSTALLATION1. Remove any bumpers that may be banded, or bolted to the frame of the dock leveler. DO NOT remove the s

Strany 6 - VIEW OF THE LEVELER

124111-0006 — Sept 2010Sept 2012INSTALLATIONInstall Dock LevelerA— Distance (Leveler Frame Height)B— Shim Locations (Under Rear Vertical Supports)C— S

Strany 7 - Safety Decals

134111-0006 — Sept 2010Sept 2012INSTALLATIONNOTE: Poweramp dock levelers are designed with a nominal 1/2 in. (12.7 mm) shimming distance to allow for

Strany 8

144111-0006 — Sept 2010Sept 2012INSTALLATIONA— Front of Dock Pit B— Dock Leveler FrameC— Side Pit Curb AngleD— Gap [3/4 in. (19 mm) Minimum]E— Pry Loc

Strany 9

154111-0006 — Sept 2010Sept 2012INSTALLATION14. Remove shipping bands at this time. Allow platform to float. Add/Remove shims as necessary to bring pl

Strany 10 - INTRODUCTION

164111-0006 — Sept 2010Sept 2012INSTALLATIONA— Safety Leg Chain Pull Ring B— Platform Maintenance Prop C — Shim Location (Under Lift Arm Pivot) D — Lo

Strany 11 - INSTALLATION

174111-0006 — Sept 2010Sept 2012OPERATIONThe CM-series mechanical dock leveler uses large lift springs (U) to apply force to lift arm (T). The lift ar

Strany 12

PageSafetyRecognize Safety Information ... 1General Operational Safety Precautions ...

Strany 13

184111-0006 — Sept 2010Sept 2012OPERATIONOperating InstructionsThe dock leveler operation instructions are divided into the two methods of loading and

Strany 14

194111-0006 — Sept 2010Sept 2012OPERATIONNOTE: If end unloading is required, see End Loading/Unloading Instructions on page 20.1. Check to make sure

Strany 15

204111-0006 — Sept 2010Sept 2012OPERATIONEnd Loading/Unloading — Platform at Cross-Traffic Position.End Loading/Unloading — Platform at Below-Dock Pos

Strany 16

214111-0006 — Sept 2010Sept 2012MAINTENANCEService Dock Leveler SafelyWhenever maintenance is to be performed under the dock leveler platform, support

Strany 17

224111-0006 — Sept 2010Sept 2012MAINTENANCEPeriodic MaintenanceA — Lip Hinge Grease FittingsB — Lip Maintenance Prop PivotC — Lip Banger PivotsD — Pla

Strany 18

234111-0006 — Sept 2010Sept 2012MAINTENANCEQuarterly MaintenanceRegular maintenance must be performed on a weekly and quarterly schedule. Weekly Maint

Strany 19 - OPERATION

244111-0006 — Sept 2010Sept 2012ADJUSTMENTSAdjust Lift Arm Spring and Lip Assist Spring TensionA — Jam NutB —Adjustment NutC — Lip Assist SpringD — L

Strany 20 - 12 in. (305 mm)

254111-0006 — Sept 2010Sept 2012ADJUSTMENTSNOTE: Adjusting the tension of lift springs (D) usually requires that the lip assist spring (C) also be ad

Strany 21

264111-0006 — Sept 2010Sept 2012ADJUSTMENTSAdjust Lip Stop BoltCheck that lip (E) is fully resting on the lip keepers (D) and at the lowest part of th

Strany 22

274111-0006 — Sept 2010Sept 2012ADJUSTMENTSThis page intentionally left blank

Strany 23 - MAINTENANCE

SAFETY 14111-0006 — Sept 2010Recognize Safety InformationRead and understand the operating instructions and become thoroughly familiar with the equipm

Strany 24

284111-0006 — Sept 2010Sept 2012TROUBLESHOOTINGSymptom Possible Cause SolutionPlatform does not rise.Heavy object(s) on platform. Remove object(s) fro

Strany 25

294111-0006 — Sept 2010Sept 2012Symptom Possible Cause SolutionPlatform rises to full height, but lip does not fully extend.Lip assist chain disconnec

Strany 26 - ADJUSTMENTS

304111-0006 — Sept 2010Sept 2012TROUBLESHOOTINGThis page intentionally left blank

Strany 27

314111-0006 — Sept 2010Sept 2012PARTSHold-Down MechanismItem Quantity Part Number Description1DOTH-2563  HoldDownAssemblyComplete,31.5”Ratchet

Strany 28

324111-0006 — Sept 2010Sept 2012PARTSBASE FRAMESITEM QTY 6’ LONG 8’ LONG 10’ LONGA 6’ WIDE 20K/50K 6’ WIDE 20K/50K 6’ WIDE 20K/50K1 16 DRFA-1003 16 DR

Strany 29

334111-0006 — Sept 2010Sept 2012PARTSFrame Components *AR = As Required1 Provide dock leveler serial number, platform size, lip size and pit depth wh

Strany 30 - TROUBLESHOOTING

344111-0006 — Sept 2010Sept 2012PARTSPlatform ComponentsAEAAAFXANAGAMAJAKALAQAOAPYZAEADACABAHCCDAEFKLMNGHJPQRSUVTX

Strany 31

354111-0006 — Sept 2010Sept 2012PARTSPlatform ComponentsContinued on next page *AR = As Required1 Provide dock leveler serial number, platform size,

Strany 32

364111-0006 — Sept 2010Sept 2012PARTSPlatform ComponentsContinued from previous pagePLATFORMSITEM QTY6’ Long 8’ Long 10’ LongA 6.0’ Wide 6.5’ Wide 7.0

Strany 33 - Hold-Down Mechanism

374111-0006 — Sept 2010Sept 2012PARTSPlatform Components6’ LONG6.0’ WIDE 25K 30K16 (4)55 A (4)55 B18 (4)55 A (4)55 B20 (4)55 A (4)55 B6.5’ WIDE16 (2)5

Strany 34 - Frame Components

24111-0006 — Sept 2010Sept 2012SAFETYOperational Safety Precautions Learn the safe way to operate this equipment. Read and understand the manuf

Strany 35

384111-0006 — Sept 2010Sept 2012PARTSPlatform ComponentsCCCBDAEEFGHJK

Strany 36 - Platform Components

394111-0006 — Sept 2010Sept 2012PARTSToe Guard/Weather Seal—OptionalItem Quantity Part Number DescriptionA 2 DOTH-2818 Channel,WeatherSeal,84”B 2

Strany 37

404111-0006 — Sept 2010Sept 2012NOTESThis page intentionally left blank

Strany 38 - 6’ Long 8’ Long 10’ Long

414111-0006 — Sept 2010Sept 2012MISCELLANEOUSCustomer InformationNOTE: Refer to illustration for left/right orientation of dock leveler. The model/s

Strany 39

STANDARD PRODUCT WARRANTYSYSTEMS, INC. warrants that its products will be free from defects in design, materials and workmanship for a period of one (

Strany 40

34111-0006 — Sept 2010Sept 2012SAFETYDo not use dock leveling device if freight carrier is too high or too low.Do not overload the dock leveling devic

Strany 41

44111-0006 — Sept 2010Sept 2012SAFETYMaintenance Safety PrecautionsALWAYS stand clear of dock leveler lip when working in front of the dock lev

Strany 42

54111-0006 — Sept 2010Sept 2012SAFETYSafety DecalsEvery 90 days (quarterly) inspect all safety labels and tags to ensure they are on the dock leveler

Strany 43 - Fax: (262) 255-5917

64111-0006 — Sept 2010Sept 2012OWNER’S/USER’S RESPONSIBILITIES1. The owner/ user should recognize the inherent dangers of the interface between the l

Strany 44 - “CM” SERIES LEVELER

74111-0006 — Sept 2010Sept 2012INTRODUCTIONGeneral InformationCM-Series dock levelers are available in the following sizes, weight capacities, and opt

Komentáře k této Příručce

Žádné komentáře